Tips To Fix A Leaking Roof
If you noticed water stains which run down the walls or extend across ceilings in your house, chances are there is a leak in the roofing system. In these situations, it is essential to fix it as soon as possible to prevent more serious problems from occurring like mould, damaged insulation or cracked ceilings. This will minimise the cost of repairs later and keep your house in the best condition. If issues are left unfixed, a full roof restoration may be required in the future which can be quite costly. If you live on the north-east coast of Australia, it’s worth getting in touch with experts – call for Brisbane roof restoration services, and see if they can solve your problem. In this post, we’ll show you five useful tips to repair a leaking roof early on.
1. Roof Vents
The most common issue on the roofing can be the cracked seams on your metal roof vents or broken housing on plastic ones. Most homeowners usually caulk these leaks, but this technique might not last long. Instead, it is better to replace the damaged vent. Also, make sure to look for and replace any missing nails on the bottom of the base.
2. Walls and Dormer
Water stains or raindrops do not only run from a shingled surface, but they can also come from the rooftop, cracks in the siding, through knotholes, or around the windows. Dormer walls provide sufficient space for water to flow in your roofing area. In these cases, caulk would be cracked, missing, or old between the window edges, corner board, or siding. Even when it seems intact, you should not seal it against the adjoining surface. Instead, it is a good idea dig around with a putty knife and replace any detected caulks with silicon latex units.
3. Step Flashings
Step flashings are typically placed along a wall which intersects the roof. They play an essential role in channelling water downward over the shingled area. But when a part becomes loose or rusted, water would flow behind it and come to your house. The best way to fix this issue is by replacing the rusted flashings. First, you should remove loose shingles and pry siding, then change the step flashings. Even though this job seems straightforward, many homeowners usually forget to fix these parts in place, which cause them to fall down and reveal the wall.
4. Tiny Holes
It can be a challenging task to deal with small leaks in the roofing since they might result in rot and other issues for an extended period even before you might notice the obvious signs of these holes. Basically, you should frequently check for any holes which come from the antenna bracket or the satellite. Once you’ve found out any misplaced or exposed nails, it is advisable to pull and patch them immediately. In fact, it is relatively straightforward to repair a tiny hole in the roofing system. However, keep in mind to do this task with flashings instead of using caulk.
5. Chimney Leaks
A leak can also happen around the chimney. For instance, flashings around a brick chimney would get rusted when they are galvanised steel at the bend on their bottom. A quick and effective solution is to slip a new flashing under the old unit with the purpose of diverting any water flowing through.